dsh-auto-continue

More about this plugin

Automatic recovery for DeepSeek Harness, in the Web UI and desktop app. When a recoverable failure interrupts a session, the plugin sends your configured continuation prompt through DSH. The engine runs inside the host process , so it keeps watching while browser tabs are closed; all tabs share that engine. Recovery is enabled by default. Continuing after successful turns is a separate, opt-in autonomous loop .

Session modes — switch auto-continue on or off beside the message input, for that conversation only. The mode menu next to the switch shows the current mode and opens Follow default, Off, Recovery only or Autonomous loop. Choices save on the host, survive restarts and sync across tabs; hiding the control does not change them - Error classification — transient failures (network / timeout / 5xx / 429…) are auto-resumed; errors classified as permanent are skipped and notified. This includes HTTP 401/403 or, except for MALFORMED RESPONSE, codes/messages matching auth, credential/API-key, balance/quota, unknown-model, or context-length/overflow keywords. Use literal custom retryable patterns for provider-specific exceptions; turning classification off allows recovery attempts for all errors - Adaptive backoff — consecutive failures wait longer each time (cooldown × factor: 20s → 40s → 80s…), up to the configured maximum - Offline hold — on by default (pauseWhenOffline).…